Boiler Maintenance in Metro Vancouver — 27-Point Tune-Up & Safety Check

Keep your boiler running safely and efficiently year-round. Our licensed technicians perform comprehensive 27-point inspections including combustion testing, safety control verification, and system optimization.

Call 778-909-5731 Schedule Maintenance

Why Annual Boiler Maintenance Matters

Safety First

Annual inspections catch carbon monoxide leaks, gas leaks, and faulty safety controls before they become dangerous. Protect your family with professional maintenance.

Peak Efficiency

A well-maintained boiler uses up to 15% less fuel. Clean burners, proper combustion settings, and optimized controls reduce your heating bills all winter.

Extended Lifespan

Regular maintenance can add 5-10 years to your boiler's life. Most manufacturers require annual service to keep warranties valid.

Our 27-Point Boiler Inspection Checklist

Every maintenance visit includes our comprehensive inspection. Here's what we check:

1. Visual Inspection

Check for signs of corrosion, leaks, or soot buildup

Inspect boiler casing and seals for damage

Verify clearances around boiler meet code

2. Combustion Analysis

Test flue gases with combustion analyzer

Check CO levels (must be below 100 ppm)

Verify proper air-to-fuel ratio

Inspect burner flame pattern

3. Safety Controls

Test high-limit safety switch

Verify pressure relief valve operation

Check low-water cutoff (LWCO) function

Test carbon monoxide detectors

4. Water & Steam Systems

Check system pressure (12-15 PSI for residential)

Inspect expansion tank pre-charge

Test automatic water feeder

Check for water leaks at all connections

5. Electrical System

Test thermostat calibration and cycle operation

Inspect wiring for loose connections or corrosion

Check igniter/spark electrode condition

Verify all control board error codes

6. Heat Exchanger & Burner

Inspect heat exchanger for cracks or corrosion

Clean burner assembly and orifices

Check venting system and draft inducer

Verify proper combustion air supply

7. Circulator Pump & Zone Valves

Check pump for unusual noise or vibration

Lubricate pump bearings if applicable

Test zone valve operation

Verify proper flow across all zones

Seasonal Boiler Maintenance Tips

Pre-Winter Tune-Up (September - October)

Schedule your annual boiler service before the heating season begins. Technicians are less busy, and you'll avoid mid-winter breakdowns. Get combustion testing, safety checks, and system optimization while the weather is still mild.

Mid-Winter Monitoring (December - February)

Check your boiler pressure gauge weekly — it should read between 12-15 PSI. Listen for unusual noises like banging or whistling. Check radiators for cold spots and bleed them if needed. Keep vents and air intakes clear of snow and ice.

Spring Shutdown (March - April)

Don't just turn off your boiler and forget it. Have a technician perform end-of-season inspection to catch any issues from winter wear. Clean the boiler jacket, check for leaks that developed during the heating season, and ensure proper summer shutdown procedures.

Schedule Your Boiler Tune-Up Today

Licensed, insured boiler technicians serving all of Metro Vancouver. Same-week appointments available.

Call 778-909-5731 Email info@RomaHeating.ca